Frozen lines, crystallized process fluids, and heat trace that quietly fails after one winter. In oil and gas, chemical plants, and power stations, an unreliable trace heating system doesn't just mean downtime — it means a production stop in the worst possible weather, often in a location that's hard to reach and harder to work in.
If you're replacing trace cable more often than the insulation on your pipes, the cable is the problem — not the winter.
Why trace heating fails in the field
Most trace failures we see aren't a mystery. They fall into three buckets:
- Moisture ingress. Water works its way into the cable at a splice, a damaged jacket, or a termination. Once inside, it shorts the conductor or corrodes it from within. The cable looks fine on the outside.
- Mechanical damage. A cable walked on, crushed under insulation, or cut during maintenance fails exactly when you need it most — in the cold.
- Temperature beyond rating. Polymer-jacketed trace near a hot line or a steam-following system cooks its own insulation, then fails.
How MI cable is built — and why it survives
Mineral-insulated (MI) heating cable is constructed differently from polymer-jacketed trace: a metal sheath, magnesium-oxide insulation, and a heating conductor sealed inside. There's no organic insulation to degrade, and no air gap for moisture to sit in.
That construction gives it two things polymer cable struggles with:
- High-temperature tolerance. The metal-sheathed, mineral-insulated construction keeps working where polymer jackets would cook.
- Mechanical ruggedness. The metal sheath shrugs off crushing, scraping, and the abuse a plant floor dishes out.
It keeps working where the environment is hot, wet, or corrosive, and where the line is buried, insulated, or in a classified area. That's why MI cable is the standard answer for process lines that cannot afford to stop.
Where MI cable earns its keep
MI cable is overkill for some jobs — and the right call for others. It earns its keep when:
- The line carries a process fluid that must not solidify, crystallize, or freeze.
- The trace is buried, insulated, or otherwise impossible to inspect or repair quickly.
- The environment is classified, wet, corrosive, or hot — the conditions that kill polymer cable.
- Shutdown is measured in lost production, not hours.
For those applications, the premium of MI cable over polymer trace is cheap insurance.
Sizing it right matters as much as the cable type
The best cable in the world fails the job if it's undersized. Three numbers matter most: the line length to heat, the power required per meter (heat loss through insulation, not just "the pipe gets cold"), and the voltage you have available. Get those three right, and the cable selection is straightforward.
We manufacture MI heating cable and pipe heaters for process industries, sized to your line length, power requirement, and installation conditions. Tell us the pipe diameter, insulation, and the coldest ambient temperature the line will see — we'll tell you what the trace should look like.
Your trace has to survive another winter?
Send us the line diameter, insulation, and worst-case ambient temperature. We'll spec the heating — and tell you honestly whether you need MI cable or not.
Talk to Our Engineer