Two types of trace heating cable. People argue about which is better. We manufacture both. Let's talk honestly.
The short version
If you're just keeping a water pipe from freezing in an unheated warehouse — self-regulating. It's cheap, flexible, easy to cut on site. Done.
If you're running a process pipe at 200°C in a chemical plant — MI cable. No question.
Everything else is in the gray area.
What MI cable actually is
Mineral-insulated cable is resistance wire packed in magnesium oxide, inside a metal tube. It's rigid. It's waterproof. It doesn't care about UV, chemicals, or physical abuse. And it runs hot — up to 600°C with Incoloy sheath.
We've seen MI cable go into service in the 1990s and still running today. There's nothing inside that degrades. The metal sheath just sits there.
The downside: it's stiff. You can't bend it like a wire. You need proper tools to cut and terminate it. It costs more per meter. If you get the installation wrong, the seal fails and moisture gets in.
What self-regulating is good at
Self-regulating cable has a polymer core between two wires. It softens when hot, resistance goes up, power drops automatically. It's flexible — you can wrap it around valves and flanges. You can cut it with a knife on site. It's much cheaper.
The problem: the polymer ages. After 5-10 years, the core breaks down. The maximum temperature is limited — most types top out around 150°C, and freeze-protection versions are even lower. You can't run it in really hot environments.
Where people make the wrong call
We see people spec self-regulating on process lines that run hotter than the cable can handle. It works for a while, then the core melts. Then they call us asking for MI cable.
Conversely, we see people spec MI cable for simple freeze protection. Overkill. You're spending 3x more for something that will last 30 years when the building probably gets renovated in 10.
The rule of thumb we use
Ask three questions: What's the pipe temperature? What's around the pipe (chemicals, outdoors, explosion zone)? How critical is it if the heater fails?
High temp + harsh environment + critical process → MI. Low temp + simple freeze protection + easy install → self-regulating. When in doubt, ask. We'd rather talk you out of an expensive MI system than sell you one you don't need.
Stuck on a heater selection?
Tell us your application — tank size, fluid, target temperature. We'll tell you what actually works, not what we want to sell you.
Talk to Our Engineer