A split-half band is two curved shells that close around the barrel like a collar. The big advantage on an existing machine is that the barrel and screw do not have to be removed to fit the heater. The work is in closing the halves evenly.
How the halves meet
Each half carries its own heating element and insulation. One side may hinge or simply butt together; the opposite side carries the clamp, bolt or spring band that pulls the two halves onto the barrel. The inner face should follow the barrel radius over the full width.
Mounting steps
- Clean the barrel surface: remove plastic residue, oil and old insulation crumbs
- Open the halves and wrap them around the barrel at the marked position
- Align the two end edges so the joint line is closed all along, not gaping at one side
- Tighten the clamp gradually and evenly; do not crush ceramic blocks or distort the shell
- Set the probe or thermocouple into its pocket against the barrel
- Route leads away from hot surfaces, moving parts and chips, with strain relief
Fit problems to watch
If the band diameter is oversize for the barrel, one half lifts off and heat leaks through the joint. If the clamp is over-tightened on a ceramic heater, the blocks can crack. A barrel with an old buildup of burnt plastic reads as a larger diameter, so the surface has to be cleaned before measuring.
Service removal
When the band needs replacement, loosening the clamp opens the halves again. This is the main reason split designs are used on production machines: maintenance does not mean pulling the barrel apart.
Close the halves so the joint line seals, tighten evenly without crushing the element, and keep the probe against the barrel. A loose or lopsided split band loses heat through the seam before it reaches the plastic.
Need split bands matched to your barrel?
Send the barrel OD, band width, set temperature and clamp style. We will build the halves with the right element and insulation.
Send Barrel Size