Silicone rubber heaters look like a flat rubber mat. We cut them to shape, drill holes, and stick them on tanks, drums, 3D printer beds and medical equipment.
What they are made of
Inside is etched foil or resistance wire sandwiched between two layers of silicone rubber and fiberglass cloth. Standard thickness is 1.5 mm or 2.0 mm. Max surface temp is 200 C continuous, 230 C short term.
- Etched foil: even heat, good for large flat areas, higher cost
- Wire wound: cheaper, hot spots between wires, better for small patches
Where they shine
Drum heating, tank bottom heating, 3D printer beds, medical blankets, semiconductor wafer chucks. Any place where a rigid heater will not fit and you need to peel and stick.
Where they burn out
Three reasons we see in the shop:
- Air gap between heater and surface - if it does not lie flat, heat builds up and the silicone cracks
- Over 2 W/in2 on a surface that does not conduct heat away - the foil delaminates
- Sharp folds during installation - the internal wire breaks at the bend
A customer in Suzhou stuck a 500W silicone heater on a stainless tank without thermal paste. It lasted 3 weeks. We sent one with 3M adhesive pre-applied and watt density cut to 0.8 W/in2. That one ran 4 years.
Mounting rules we follow
- Clean the surface with alcohol before sticking
- Use pressure-sensitive adhesive or vulcanize it on
- Do not fold tighter than 20 mm radius
- Keep leads away from hot edges - use fiberglass sleeve
Need silicone heaters shaped to your part?
Send us a drawing or the tank dimensions. We will spec watt density and leads.
Send Your Specs