A quartz infrared tube radiates heat in all directions. Without a reflector, the energy aimed backward into the housing is wasted. The reflector is what turns a glowing tube into a directed heater aimed at the part.
What the reflector does
The tube sits in front of a shaped reflector. Radiation leaving the rear side bounces off the reflector surface and heads toward the workpiece. Reflector material and finish affect how much of that energy is returned:
- Polished aluminum: common good reflector, lighter and lower cost
- Gold-coated: high reflectance at infrared wavelengths, used where efficiency matters most
- Ceramic or coated metal: protective where dust, splash or chemical vapor reaches the housing
Shape sets the beam
A concave or parabolic reflector focuses energy toward a line or spot; a flatter reflector spreads it over a wider area. The choice depends on whether the job needs a focused line for a passing product or a broad panel over a tray or web. Tube length, reflector depth and distance to the part work together.
Building an array
Several tubes are mounted in a bank to cover the workpiece width. Spacing and row position decide how even the heat is across the surface.
- Tube spacing set so beams overlap in the working plane, leaving no cold strip between tubes
- Distance from the part: closer gives higher intensity but a narrower, hotter zone; farther spreads the heat
- Staggered rows help where a single row leaves uneven coverage
- Elements can be staged so the bank matches warm-up and holding demand
Why efficiency drops on older units
Reflectors collect dust, overspray and oily vapor. A dirty or oxidized surface stops bouncing energy back, and more heat stays in the housing. Tubes also darken or age toward end of life, dropping output. Clean reflectors on a service schedule and check tube color and current against new units.
Typical applications
Quartz infrared arrays appear in paint and coating drying, plastic preheating, web and sheet warming, and compact curing stations where fast radiant heat is needed without heating the whole air volume first.
Output is the tube wattage times what the reflector actually returns. A good array overlaps its beams on the part, and a dirty reflector quietly wastes the same watts. Keep mirrors clean and match spacing to the product width.
Designing an infrared array for a line?
Send part size, line speed, target temperature and whether the heat is focused or spread. We will lay out tube count, reflector type and spacing.
Send Line Details