PTFE Heater Welding: Why Every Seam Gets a Leak Test

PTFE (Teflon) coated tubular heaters go into nickel plating tanks, etching tanks and anodizing lines. The PTFE film protects the steel sheath from acid.

How it is made

The tubular element is cleaned, then PTFE powder is sprayed on and sintered at 380 C. Coating thickness is 0.4 to 0.6 mm. Every seam and bend must be fully covered.

Leak testing

Before shipping, we put each heater in a water bath and apply 1000V between the sheath and a probe. If there is a pinhole, current leaks and the tester trips. A bad heater gets re-coated, not shipped.

Where it fails

Edges and bends are thin spots. If the installer scratches the coating with a wrench, acid creeps under and the element corrodes from inside.

A plating line in Shenzhen had PTFE heaters failing in 3 months. We found installers were dropping them into the tank, chipping the coating on the edge. We added PTFE edge guards and trained them to lower slowly. Now they last 2 years.

Need PTFE heaters for acid tanks?

Tell us the acid type and concentration. We coat and leak test every unit.

Send Your Specs
Get a Quote