Every oven has a PID controller. Out of the box it swings 20 C above setpoint then 10 C below. People think the oven is broken. It just needs tuning.
What P, I, D do
- P (Proportional): how hard to push toward setpoint. Too high = overshoot. Too low = slow to reach temp.
- I (Integral): remembers past error. Stops the steady offset where the oven sits 5 C below setpoint forever.
- D (Derivative): reacts to rate of change. Slows the heat as it approaches setpoint to prevent overshoot.
Manual tuning method
- Set I and D to zero. Turn P up until the temperature oscillates. Note that P value.
- Set P to half of that oscillation value.
- Turn I down (start at 600 seconds, work lower) until the offset goes away without oscillation.
- Turn D up (start at 30 seconds) to dampen overshoot.
A customer's oven overshot 40 C every time. P was at full, I was at 10 seconds. We set P to 8, I to 200, D to 20. Oven reached 150 C in 12 minutes with 3 C overshoot. Done.
Auto-tune
Most modern PID controllers have an auto-tune button. Press it, the oven heats up and cools once, and the controller learns the P I D values. Walk away for 30 minutes. It works 80% of the time.
Need a PID controller with SSR built in?
Tell us your temp range and thermocouple type. We set up the panel.
Send Your Specs