The temperature controller is the brain of your oven. Cheap on-off controllers are fine for drying. Precision processes need PID.
On-off control
Heater is either full on or full off. At setpoint 150 C: heater turns on at 145 C, runs until 155 C, cycles. Temperature swings 10 C. Simple, cheap, good for curing and drying where a few degrees do not matter.
PID control
PID stands for Proportional-Integral-Derivative. The controller calculates how much power to apply, not just on or off. It uses SSR (solid state relay) to modulate power. Temperature holds within +/- 1 C.
When to use which
- On-off: powder coating, drying, baking where tolerance is +/- 10 C
- PID: curing, annealing, semiconductor, any process where 5 C changes the result
A customer in Suzhou made lithium battery electrode drying. They needed +/- 2 C uniformity. On-off controllers swung 15 C and 10% of coils had defects. We retrofitted PID + SSR, defect rate dropped to 0.5%.