Watt density (W/cm2) on the sheath surface is the single most important number for immersion heater life.
Guidelines we follow
- Water, turbulent flow: 8 to 10 W/cm2
- Water, still tank: 5 to 6 W/cm2 max
- Light oil (engine, hydraulic): 3 to 4 W/cm2
- Heavy oil or tar: 2 to 2.5 W/cm2
- Corrosive chemicals: 2 to 3 W/cm2
What happens if you go too high
The right side of the heater boils locally even though the bulk liquid is cold. Steam bubbles form on the sheath, they insulate, the sheath overheats, and you get a hot spot that burns open.
A tank heating hydraulic oil ran 12 W/cm2. Elements lasted 2 months. We redesigned with more elements spread out, dropping to 2.5 W/cm2. Same total power, elements now run 5 years.
Surface area math
Watt density = total watts / heated sheath area. Area = pi x diameter x length. For a 1 inch (25.4 mm) tube, 1 meter long: area = 0.08 m2 = 800 cm2. So a 6000W element runs at 7.5 W/cm2.
Need immersion heaters sized right?
Tell us the fluid, tank size and target temp. We will calculate watt density.
Send Your Specs