If your immersion heater lasts 6 months instead of 3 years, scale is almost always the reason. We pull failed elements out of tanks and the sheath looks like a limestone pipe.
Why scale kills heaters
Scale is 10 times worse than air for heat transfer. The sheath runs hot even though the water is cold. A 3 W/cm2 element with 2 mm of scale sees sheath temp jump 150 to 200 C. The nichrome wire overheats and opens.
How to tell scale is the problem
- Tank takes longer and longer to heat up
- Sheath looks white or chalky
- Element trips breaker immediately when turned on
- Top of element looks clean, bottom is caked
Cleaning methods
- Food grade citric acid: soak 4 to 8 hours, good for light scale, safe
- Phosphoric acid: stronger, use on calcium scale, ventilate
- Mechanical scraping: never use a wire brush on Incoloy - you scratch the surface and pits start corrosion
A water tank customer in Tianjin had us replace 6 flanged heaters every year. We told them to drain and acid soak twice a year. Now they replace one every 3 years. The acid cost is 200 RMB a year, the heater was 8000 RMB each.
Prevention
- Keep water pH between 7 and 9
- Use soft water above 60 C
- Lower watt density to 5 W/cm2 if water is hard
- Drain and flush the tank every 6 months
Tired of replacing immersion heaters?
Tell us your water quality and tank volume. We will spec the right alloy and watt density.
Send Your Specs