The nozzle is where plastic drops from the manifold into the mold. If it is too cold, you get cold slugs. Too hot, you get stringing and drool.
Two types
- Coil heater (spring type): bends around the nozzle, full contact, even heat, good for 16 to 32 mm nozzles
- Band heater (nozzle band): split design, clamps on, easier to remove, good for larger nozzles
Wattage
Nozzles are small. A typical 22 mm nozzle gets 200 to 300W total. Watt density runs high - 6 to 8 W/cm2 because the nozzle conducts heat away fast into the mold.
Thermocouple position
Built-in J type thermocouple at the middle of the heated zone. If the thermocouple is at the top near the lead, the controller reads hotter than the actual plastic and the gate freezes.
A packaging mold shop had 8 cavities with 2 dropping every shot. We found thermocouples were at the top of the nozzle. Moved them to the middle, gate temp reading dropped 15 C, actual plastic temp rose 10 C. Dropping stopped.
Need nozzle heaters for your hot runner?
Tell us nozzle OD, length and voltage. We match your system.
Send Your Specs