The manifold in a hot runner system holds the plastic at melt temperature from the sprue to each gate. Heating it evenly is a layout problem: fill the plate with heaters and you still can leave cold spots at channels, corners and gate drops.
Where the heat has to reach
Melt channels run through the manifold block. Cartridge heaters or milled heater channels sit alongside those bores so heat conducts into the mass around the plastic path. The goal is a steady block temperature along every branch, not a hot middle that cools toward the ends.
Layout principles
- Place heaters close to the channel centerline, mirroring the path on both sides where possible
- Add heat near feed points, long branches and gate drops where the block loses more heat to the mold
- Watch corners and dead ends: block mass there can sit cooler than the straight run
- Balance heater groups so no section depends on one overworked rod
Cold spots and hot spots
A cold spot near a gate lets plastic stiffen, causing short shots, stringing or discolored freeze material. A concentrated hot spot degrades the resin, leaving burnt specks or pressure drop in the channel. Even power spread across the block avoids both extremes.
Probe position matters
A thermocouple mounted in a heater pocket reads the heater side, not the channel side. Place the probe near the melt channel or gate region so control follows the plastic temperature. If the controller reads warm while the part shows cold gates, the probe and the actual hot zone are not at the same place.
Build and service
Heaters should fit their bores with good contact, and leads exit clear of moving clamp halves. On older manifolds, worn rods or loose probes show up as uneven gate temperatures even where the original layout was sound.
Layout the heat around the channel path, not around empty block space. Cover feed points and gate drops, mirror the branches, and put the probe where the plastic actually flows. Even temperature at the gates is the proof the layout works.
Need manifold or nozzle heaters for a hot runner?
Send the manifold layout, gate count, resin temperature and heater voltage. We will match rod or channel heater placement and probe pockets.
Send Hot Runner Specs