Hot Runner Coil Heater Problems We See Every Week

Hot runner coil heaters are consumable parts. They wear out. But if you're replacing them every few months, something's wrong. Here's what we see on the factory floor.

"It won't heat at all" — open circuit

The most common failure. The resistance wire inside the coil has broken. Sometimes it's just old age — they're not designed to last forever. But if it's a new coil, look closer.

Did someone stretch the spring when installing it? Over-stretching fatigues the wire. Is the nozzle running hotter than rated? If your controller says 230°C but the thermocouple is off, you're actually at 260°C, and the wire cooks faster.

"The nozzle is cold in spots" — bad contact

The heater's on, but the temperature is uneven. More often than not, the coil isn't gripping the nozzle tightly. Flashing or buildup on the nozzle body gets in the way. Clean the surface before you install a new coil. Make sure the spring compresses fully.

If the coil is deformed or stretched out of shape, replace it. Don't try to force it on.

"The temperature reading is wrong" — thermocouple

J-type and K-type are not interchangeable. If someone mixed up the types, the controller reads the wrong temperature. You get overshoot or poor control. Check the type matches what your controller expects.

Also check the wires at the junction. They break from heat cycling. A broken thermocouple wire reads as a sensor error, or worse — a bad reading.

"The leads are burned" — wire exit point

Where the wires come out of the coil is the weakest point. Heat cycles, repeated bending, contact with hot nozzle surfaces — the insulation fails, you get a short.

Route the leads away from hot surfaces. Use metal braid or conduit where they pass near hot metal. Don't make a sharp bend right at the exit — stress fractures the wires.

"We go through them like candy" — wrong spec

If you're replacing coils more than twice a year on the same nozzle, you've got a sizing problem. Check: is the coil rated for your actual operating temperature? Are you running over voltage? Is the coil diameter the right size for the nozzle?

Send us the nozzle size and operating temp. We'll spec a coil that actually lasts. The cheap ones save money on the purchase order and cost you on the production floor.

Stuck on a heater selection?

Tell us your application — tank size, fluid, target temperature. We'll tell you what actually works, not what we want to sell you.

Talk to Our Engineer
Get a Quote