The sheath is the part that touches the process. Pick it from the fluid, temperature and corrosion condition; the rated kW does not decide the material. A good heater in the wrong sheath corrodes or oxidizes long before its wiring wears out.
Common sheath options
- 304 stainless: general water and mild services, air and non-corrosive heating. Affordable, good formability, limited against chloride and strong acid.
- 316L stainless: better corrosion resistance than 304, used where water chemistry is harder or mild chemicals are present. The low-carbon grade resists weld-related corrosion.
- High-alloy sheath (Incoloy type): higher temperature resistance and better oxidation in hot oil, air and more aggressive services. Used where stainless runs hot or discolored.
- Titanium: for chloride-bearing liquids such as some plating and seawater-type duties, where stainless pitting starts.
- PTFE-coated sheath: lined or coated for strong acid and alkaline tanks, protecting the metal from direct chemical attack; coating sets the lower temperature ceiling.
Selection steps
Work through the order rather than grabbing a familiar grade:
- What is touching the sheath: clean water, hot oil, chemical solution, humid air or corrosive gas?
- What is the maximum working temperature, and does the sheath run above the fluid at any point?
- What is the corrosion type: pitting from chloride, acid attack, oxidation, or scaling?
- Are there cleaning cycles, washdowns or residual chemicals that sit on the sheath at shutdown?
- Balance material cost against expected service life in that duty
Common mismatches
A 304 sheath in a hot oil tank at high setpoint can oxidize and scale on the surface. Stainless in a chloride plating bath pits fast despite looking heavy-duty. A PTFE liner chosen for acid service cannot carry a high-temperature application. Each material has a ceiling both on chemistry and on heat.
When to ask for a check
If the fluid mix, concentration or temperature is unusual, give the fluid name, concentration, working range and any residual after shutdown. The sheath, welds and lead exits all need to suit the same condition; a corrosion-resistant tube with a plain steel head defeats the choice.
Choose the sheath for what touches it and how hot it gets, not for the kW. Match the head, welds and exits to the same condition, and keep the material within its temperature ceiling.
Unsure which sheath fits your fluid?
Send the medium, concentration, temperature and whether it circulates. We will recommend the sheath grade and build the element to match.
Ask About Material