An immersion heater does not weld to the tank body directly. It bolts through a flange fixed to the tank nozzle. If the flange type does not match the pressure, temperature and how often you open the tank, you end up with a leak or a joint that will not line up.
Slip-on plate flange (PL)
This is the plate flange most heater bundles use. The tube or bundle passes through the flange bore and is fillet-welded on both sides. It is easy to make, easy to fit and the standard choice for low and medium pressure water, oil and air tanks.
- Common on open tanks, water tanks and hydraulic oil reservoirs
- Low to medium pressure: PN10, PN16 or Class 150
- Rigidity is limited; avoid it for high vacuum or strongly hazardous service
Weld neck flange (WN)
The weld neck has a tapered hub that butt-welds to the tank nozzle. The joint is a full penetration weld that can be inspected by radiography. Use it where pressure or temperature is high, or where the service is flammable.
- High pressure and high temperature tanks
- Better fatigue resistance under thermal cycling
- Heavier and more expensive than a plate flange
Threaded flange (Th)
Where welding on site is not allowed, the flange screws onto a threaded nozzle or pipe. It appears on small-bore screw plug heaters and retrofits where a welded joint is impractical.
- Small bore connections only
- No welding required on site
- Thread sealing depends on the thread fit and sealant
Lap joint flange (PJ)
The loose flange sits over a stub end welded to the pipe. The flange itself can rotate, which makes bolt holes easy to align. Pick it for non-ferrous tanks or joints that are opened and reassembled often.
- Easy bolt alignment during repeated disassembly
- The loose half can be carbon steel while the stub end is stainless
- Lower clamping strength than a fixed flange
For most immersion heater jobs a slip-on plate flange at PN16 or Class 150 is enough. Move to weld neck only when pressure, temperature or flammable fluid calls for it, and keep a threaded or lap joint for the situations those types cannot cover.
Need a flange immersion heater matched to your nozzle?
Tell us the tank size, fluid, temperature and pressure rating. We will match the flange type, DN and bolt pattern for you.
Send Your Specs