When a flange immersion heater arrives and does not fit the tank, it is almost always one of three things: the bore size does not match, the bolt holes do not line up, or the insertion depth is wrong. These are fixed on the drawing before production, not on site with a hammer.
DN and bolt pattern
The heater flange must carry the same nominal diameter and standard as the tank nozzle. A DN100 nozzle expects a DN100 flange; mixing a PN16 plate with a Class 150 mating can leave the bolt holes a few millimeters off. Before ordering, confirm:
- Nozzle DN and the flange standard (GB/T, HG/T or ASME B16.5)
- Pressure class and facing type on the existing nozzle
- Number and diameter of bolt holes, and their pitch circle
Wetted length
The heated section of the bundle has to stay under the liquid surface at all times. If the insertion length is too short, part of the element sits in vapor or air above the low level and burns out fast. If it is too long, the tubes touch the tank bottom, internal coils or agitator.
- Measure from the flange face to the lowest operating level, then add a safety margin
- Leave clearance to the tank bottom, drain outlet and any internal pipework
- Account for liquid level drop during pumping or heating cycles
Headroom for service
The junction box and cable exits sit above the flange. Make sure there is enough headroom to lift the heater straight out for cleaning or replacement, and that the wiring can be routed without bending the lead exits sharply.
What to send with your inquiry
A sketch or nozzle drawing speeds up the build. Useful details: tank inside diameter, nozzle DN and standard, minimum and maximum liquid level, distance from nozzle to tank bottom, fluid, working temperature and pressure.
Fit the flange to the nozzle standard, size the wetted length to the lowest level with margin, and leave room to lift the heater out. Send those three numbers and the heater will drop straight in.
Need a flange heater built to your nozzle?
Share the nozzle drawing and level measurements. We will match the flange, bolt pattern and tube length, and test the bundle before shipment.
Send Your Drawing