The flange heater bolts to the tank nozzle. Between the flange and the tank is a gasket. Get this wrong and you get a slow leak that drips on the floor.
Gasket materials we stock
- EPDM rubber: water up to 120 C, cheap, do not use on oil
- NBR (nitrile): oil up to 110 C, standard for hydraulic tanks
- PTFE envelope: acids and chemicals up to 180 C, inert, expensive
- Graphite spiral wound: steam and hot oil up to 450 C, for high pressure
- Copper ring: high temp oil, reusable, metal on metal
Common mistakes
Customer sends us a flange for hot oil at 200 C and asks for a rubber gasket. We have to explain: rubber turns to tar at 150 C, it will leak in a week.
A tank in Shandong was leaking hydraulic oil. They kept tightening the bolts. We checked - they used EPDM on oil at 80 C. EPDM swells in oil. Swapped to NBR, leak stopped.
Bolt torque
Do not crank it down. For a 6 inch 150# flange, torque bolts to 30 Nm in a star pattern. Overtighten and you warp the flange face, undertighten and it leaks.
Need a flange heater with the right gasket?
Tell us what fluid, what temp and what pressure. We include the correct gasket.
Send Your Specs