Two flanges can have the same DN and pressure class and still not seal, because the facing on the flange face is different. The facing decides what gasket sits in it and how much bolt load that gasket needs.
Raised face (RF)
The raised face is the most common on heater flanges. A narrow circular ring stands proud of the flange face and concentrates the gasket load on that ring. It works with sheet gaskets, spiral wound gaskets and ring type gaskets.
- Standard choice for water, oil and steam tanks
- Gasket is sized to the raised ring, not the full flange
- Both mating flanges must be RF on the same height
Flat face (FF)
The whole face is flat. A full-face gasket covers the entire flange and reaches the bolt holes. Flat face joints are typical with cast iron flanges and low-pressure service. Do not force a full-face gasket onto a raised face joint.
Tongue and groove (TG) and male/female (MFM)
One flange has a tongue, the other a matching groove. The gasket sits inside the groove and cannot slide sideways. This facing is used where the fluid leaks easily or the joint sees strong pressure fluctuations.
- Gasket location is fixed, no extrusion outward
- Needs lower bolt load than a wide flat joint
- Careful alignment matters during assembly
Ring joint (RJ)
A machined groove holds a solid metal ring (octagonal or oval). RJ faces appear on high-pressure, high-temperature piping and boiler connections. The metal ring deforms slightly under bolt load to form the seal.
Before you bolt up
Whatever the facing, the sealing surface has to be clean and undamaged. Rust, a circular scratch from a wrench, weld spatter or a bent gasket all leave a leak path. The gasket material itself is chosen by fluid, temperature and pressure; the facing is chosen to match it.
Match facing to gasket: RF with RF sheet or spiral wound, FF with a full-face gasket, TG with a confined gasket. A gasket that does not fit the facing will leak no matter how hard you tighten.
Ordering a flange immersion heater?
Tell us the mating flange facing and gasket type. We machine the heater flange to the same face and supply the matching gasket.
Send Your Flange Drawing