In air heating, a plain tubular element runs naked. Air is a poor conductor, so the sheath runs hot and you waste wattage. Finned tubes add surface area - 2 to 3 times the bare tube - which means lower sheath temperature and longer life.
When to use finned tubes
- Duct heaters and HVAC air heating
- Oven recirculation systems
- Forced convection drying
- Any air velocity below 10 m/s
We build finned tubular elements with aluminum or stainless fins, spaced 2 to 5 mm apart. Too close and dust clogs them; too wide and you lose the surface area benefit.
When plain tube is fine
- Liquid immersion - the liquid carries heat away
- High-velocity air above 15 m/s
- Clean low-temperature air where sheath temp stays low
A 10 kW finned tube at 3 m/s runs at roughly 350 C sheath. The same 10 kW plain tube hits 600 C and oxidizes in months. The fins pay for themselves in element life.
Need finned tubular elements?
Tell us the duct size and airflow. We will build the right fin spacing and watt density.
Get a Quote