Extruders and injection molding machines use band heaters around the barrel. The two main types are ceramic and mica. We build both.
Ceramic band
- Runs to 600 C surface temperature
- Infrared radiant heat, more efficient
- More expensive, bulkier
- Better for high-temperature processes
Mica band
- Runs to 350 to 400 C max
- Thin, fits tight around the barrel
- Cheaper, easier to replace in the field
- Good for general extrusion and molding
If your process runs below 300 C, mica band is fine and saves money. Above 400 C, or if you want faster heat-up, go ceramic. We have seen customers run mica bands at 450 C - they carbonize in 2 to 3 months.
Need replacement band heaters?
Send us the barrel OD, width, voltage and wattage. We will match the fit.
Get Replacement Bands