Cartridge heaters fail at the lead exit more often than they fail in the heated section. We have boxes of returned elements where the tube is fine but the wire is broken.
Lead types
- Silicone rubber leads: 200 C max, cheap, standard for low temp
- Fiberglass braid: 350 C, for mold bases up to 300 C
- Magnesia sealed with stainless conduit: 500 C, high temp dies
- High temperature nickel leads: no insulation, for inside hot zones
Bend radius
Never bend the lead closer than 15 mm from the heater end. That is where the cold zone starts - bend there and you crack the seal, moisture gets in and the element shorts to sheath.
Strain relief
If the machine pulls on the leads, add a spring or flexible conduit. We see leads pulled out of the heater by robot arms in die casting shops.
A die caster in Foshan broke 8 cartridges a month. We added a 90 degree lead exit with stainless flexible conduit and a spring strain relief. Zero failures in 18 months.
Need cartridges with heavy-duty leads?
Tell us the lead length, exit direction and max temp. We build to order.
Send Your Specs