Cartridge heaters are rated by watt density (W per cm2 of heated sheath surface). Get this number wrong and your heater fails in months.
Guidelines we use
- Plastic mold heating: 6 to 8 W/cm2
- Hot runner nozzles: 5 to 7 W/cm2
- Platens and presses: 8 to 10 W/cm2
- Still air: 3 to 5 W/cm2 max
- Liquid heating: 10 to 15 W/cm2
The fit between cartridge OD and hole matters too. If the hole is 0.1 mm bigger than the cartridge, air gap kills heat transfer and the sheath runs hot. We recommend a slip fit of +0.05 to +0.1 mm.
A 1000W cartridge at 6 W/cm2 outlasts the same 1000W at 15 W/cm2 by 5 to 10 times. The cost difference is tiny compared to mold downtime.
Need cartridges built to your mold?
Send us the hole diameter, heated length, voltage and material. We will spec the right watt density.
Send Your Drawing