An aluminum foil heater is a thin flexible heating pad. A resistive circuit is laid across an aluminum foil backing and sandwiched with insulation, so heat spreads evenly through the foil instead of staying on a wire path.
How it is built
- Aluminum foil backing spreads heat across the pad area
- Resistive wire or foil trace carries the power, routed in an even pattern
- Insulating film above and below protects the circuit and blocks contact to metal
- Lead wires exit at a sealed pad edge; a thermostat or sensor can be added
The pad stays flat and light, and it conforms to a panel surface rather than forming around a hot barrel the way a cast or band heater does.
Where foil heaters are used
- Warming control cabinets, instrument enclosures and small boxes against condensation
- Panel heating in display cases, coolers and frost-prone equipment
- Keeping pipes, valves or small tanks above freezing in winter
- Backing pads on flat plastic or wood assemblies needing gentle even heat
Temperature and mounting limits
Foil pads are made for low to moderate surface temperatures. They are not a substitute for high-temperature barrel or duct heaters. On mounting:
- Apply to a clean, flat surface; the foil bonds best where it lies fully down
- Secure with adhesive film or aluminum tape; do not fold or crease the circuit path
- Keep lead exits away from sharp edges and moving parts
- Size watts to the panel area, not to a high spot on the pad
How to order the right pad
Useful details: pad length and width, the surface it bonds to, target temperature, ambient low temperature, voltage, and whether a built-in thermostat is wanted. Irregular outlines can be cut to the panel shape.
Aluminum foil heaters do even, gentle work on flat surfaces in the low-to-moderate range. For high-temperature barrels, ducts or heavy tanks, a tubular, band or cast heater is the right structure instead.
Need a foil pad made to your panel?
Send the outline, surface material, target temperature and voltage. We will lay out the circuit and pad size, with a sensor option if needed.
Ask About Foil Pads